Advertisement
Step 5
Step 6
DETAIL A
DETAIL B
1/4" FPT
5167097
Manifold
*** The Sprayer should now be ready for use ***
Assembly Procedure (800-ATV25DXBL)
After your boom is attached, locate the 48" hose and
the (2) hose clamps from the parts bag.
Place the hose clamps over each end of the hose
loosely. Slip the ends of the hose over the hose barbs
on both the manifold and on the center nozzle. Use a
twisting motion, if necessary, to get the hose fully onto
each barb. Bring the hose clamps to the connection
point and tighten securely.
NOTE:
Make sure this boom feeder hose does not end up on
the 'outside' of the spray wand hose, otherwise un-
wrapping the spray wand hose from around the tank
may be difficult.
Detail A: Install the pressure gauge. Hand tighten
securely. ** DO NOT OVER-TIGHTEN **
Detail B: Screw the lid onto the tank. Place the end of
the lanyard through the tab in the tank. This
is so the lid can 'hang' off the tank when
filling/rinsing the tank out.
Detail C: Locate the (2) clips and (2) phillips head
machine screws from the parts bag.
A phillips head screwdriver is required for this step
Place a screw through the hole in the clip and bring it
up to the tank, where the embossments for the clips
are (located on the rear side of the tank)
Secure the clip/screw to the tank. Tighten so that the
clip is secure. Do this for each clip.
** DO NOT OVER-TIGHTEN **
The spray wand will snap into the clips once installed.
Do not use excessive force when placing the spray
wand into the clips, as this could cause the clips to
break.
Lanyard
Connection
Tab
Lid
Lanyard
DETAIL C
5117334
5053112
Page 5
Advertisement
