Table of Contents
Advertisement
ACCESSING LOCAL MANAGEMENT
NOTE: If using a PC with a 25-pin connector, attach a DB-9 to DB-25
converter to the PC to enable LM access connection.
The pinout configuration for a 9-pin to 25-pin (Modem connection) cable
is listed as follows.
9-Pin Male Connector
(Module End)
Pin 2 (Transmit)
Pin 3 (Receive)
Pin 5 (Signal Ground)
Pin 7 (Request to Send)
Pin 8 (Clear to Send)
2.2.2 Connecting the Console Cable to a Terminal
To establish a connection between the TRMM/TRMMIM and the
management terminal:
1. Attach the male 9-pin connector to the RS232 port labeled COM 2, or
CONSOLE, on the front of the management module.
2. Attach the female end (25-pin for a VT series terminal or 9-pin for
PCs, as applicable) to the RS232 COMM port on the terminal.
2.3 ACCESSING LOCAL MANAGEMENT
The TRMM/TRMMIM supports only one LM session (from either a
management terminal, modem, or Telnet) at a time. See Section 2.3.1 for
information about LM access restrictions.
To access Local Management:
1. Power on the MMAC in which the management module is installed.
2. Power on the terminal. After a brief warm-up, the Password screen
appears (see Figure 2-2).
2-4
to
25-Pin Male Connector
(Modem End)
to
Pin 2 (Transmit)
to
Pin 3 (Receive)
to
Pin 7 (Signal Ground)
to
Pin 4 (Request to Send)
to
Pin 8 (Carrier Detect)
Advertisement
Table of Contents
