Table of Contents
Advertisement
Operating manual SW GII 64006..., 6407..., 6408...
4.3
Accessories
4.3.1 Limit switch (optional)
Non-contact, 230 V AC / 24 V DC
4.3.2 5/2-way solenoid valve (optional)
230 V AC / 24 V DC
The technical data sheets for the accessory parts are in the appendix.
5
Commissioning
This work may only be carried out by trained personnel who have been authorised to do so.
Before beginning work on the JAUDT distributor valve, you must make sure that the drive has been switched
off/disconnected and that the control room has been informed of the work.
Secure the system/shut-off element against inadvertent activation/opening.
The safety officer and/or the environmental protection officer may need to be informed before work begins.
It is of course essential that the distributor valve is always open in one direction, i.e. care must be taken to
ensure that silos above it are emptied.
JAUDT distributor valves can be fitted with limit switches to provide "OPEN - CLOSED" position feedback.
The limit switches are adjusted in the factory. The setting must be checked during commissioning and
adjusted as required (see 6.1).
Follow the manufacturer's operating instructions if the unit is fitted with an electric drive!
©SW_GII_EN_Rev02-2010.DOC
Caution! Danger of death from electric current!
Work on the electrics must be carried out by a trained electrician.
Caution! Danger of injury!
If hot or aggressive media or aerosols are distributed through the JAUDT distributor valves,
suitable protective measures must be taken before work on the valve begins. This includes
protective clothing, breathing masks and the provision of collecting containers.
Caution! Danger of injury!
With powered JAUDT distributor valves, the drive must be sufficiently protected that there is
no risk of any injury. This protection must be provided by the system operator unless it is
included in JAUDT's scope of supply.
Page 6 of 15
Advertisement
Table of Contents
