Declaration Of Incorporation - JAUDT SW GII 6406 Series Translation Of The Original Operating Instructions

Operating manual SW GII 64006..., 6407..., 6408...
12

DECLARATION OF INCORPORATION

within the meaning of EU Directive 2006/42/EC, Annex II Part 1.B
Manufacturer, address
Documentation officer
Product denomination / Device Type
The above partly completed machinery is governed by the requirements of Directive 2006/42/EC Annex I,
its general principles and its Part 1 and where appropriate Point 2.1. If used in areas at risk of explosion
Directive 94/9/EC (ATEX) also applies.
The fundamental requirements 1.3.3 and 1.3.4 can be ensured. The above requirements can only be
ensured through proper installation.
In addition, the above product conforms in the supplied version to the provisions of Directive 2006/95/EC
"Low Voltage Directive" and 2004/108/EC "Electromagnetic Compatibility".
For the purposes of assessment of conformity the manufacturer produced the special technical
documentation pursuant to Directive 2006/42/EC Annex VII Part B. This documentation will be sent to the
authorities of the individual member states in file form on justified request.
The above partly completed machinery is intended solely for incorporation in another machine.
Commissioning is prohibited until it has been ascertained that the machine / system into which the partly
completed machinery is to be incorporated meets the requirements of all the above directives.
JAUDT Dosiertechnik GmbH
Raiffeisenstraße 3-5
D-86167 Augsburg
Augsburg, 22.03.2010
©SW_GII_EN_Rev02-2010.DOC
JAUDT Dosiertechnik
Maschinenfabrik GmbH
Raiffeisenstr. 3 - 5
86167 Augsburg
Tel. ++49 (0)821 79605-0
Wolfgang Morell, JAUDT Dosiertechnik GmbH
Distributor valve / 6406..., 6407..., 6408...
Robert Roßkopf
Managing Director
Page 14 of 15