Table of Contents
Advertisement
Operating manual SW GII 64006..., 6407..., 6408...
4
Operation and installation
4.1
Operation
JAUDT distributor valves can be supplied to order with the following control devices:
Hand lever
Pneumatic cylinder
Electric drive
The position of the flap can be identified as follows:
on manually actuated distributor valves by the position of the hand lever;
on pneumatically actuated distributor valves, by the piston rod of the cylinders;
on units with an electric drive, by the drive itself (position indicator) or with a lever gear, by the position of
the lever.
The controller provided by the client for units with an electric drive must shut down the unit after receiving
signals from the limit switches at the two limit positions.
You must also follow the instructions given in the attached operating manual for the electric servo drive!
Attention! Material damage!
Limit switches must be set exactly before operation and the drive must be protected
against overloading.
4.2
Installation
4.2.1 Installation position
Install the distributor valve with a vertical flow direction.
For all other installation positions, please consult JAUDT.
4.2.2 Installation instructions
JAUDT distributor valves can be installed without special tools or equipment by suitably trained personnel.
Electrical work must only be performed by an electrician with the relevant training and instruction.
The following must be ensured during installation:
Mating flanges must be absolutely parallel with the flanges of the distributor valve.
All flange surfaces must be clean.
Align the JAUDT distributor valve precisely with the pipes.
JAUDT distributor valves must always be installed without stresses.
be tightened crosswise.
The distributor valve must be correctly earthed if there is a risk of electrostatic charge.
©SW_GII_EN_Rev02-2010.DOC
The fixing elements should therefore
Page 5 of 15
Advertisement
Table of Contents
