Table of Contents
Advertisement
system in the personal template. If the received MDC code is
same as the one set in the system, it can decode successfully.
After the radio received the correct MDC signaling, according to
the "Receive squelch mode"set by the user, the squelch will
be ON. Then, the radio can receive the call and the orange LED
light flashes.
2) MDC encode
If the PTT ID of the chosen channel is set as MDC, the MDC code
will be transmitted when calling.
TROUBLE SHOOTING GUIDE
NO.
PROBLEM
1
The radio cannot
Battery pack may not be installed properly.
be switched on or
Remove the battery pack and install it again.
no display after
Battery power may be insufficient. Recharge
switched on.
or replace the battery pack.
The battery
2
The battery life is finished; please replace it
power consume
with a new battery pack.
quickly after
charging.
The frequency or QT/DQT Signallings are not
Cannot talk to or
3
identical and please reprogram it.
hear others in
Make sure the SP un-mute setting of the
your group.
selective Signalling 5-Tone in user solution is
proper.
Out of the communication range.
Other voices from
Change the QT/DQT tone, and make sure
4
19
SOLUTION
non-group
change the tone on all radios in your group.
members are
Please set 5-Tone selective Signalling on the
heard on the
channel.
channel.
Communicati
Make sure the antenna is well connected.
5
on range is
Make sure the antenna is the original one.
too short.
Check if the battery power is in the normal state.
Ask your local dealer to adjust the squelch level.
Make sure the PTT button has been pressed
completely.
Unable to
Battery power may be insufficient. Recharge or
6
transmit.
replace the battery pack.
Transmitting frequency has not been set on the
channel or the radio has been remote killed.
Battery power may be insufficient. Recharge or
Noise is too
replace the battery pack.
7
loud.
Out of the communication range.
■ MAJOR SPECIFICATIONS
RP7200
Frequency Range
(1) 136~174
(MHz)
RF Power
5W (H) / 1W(L)
Spurious and Harmonics
≤-70 dB
Frequency Stability
±
Maximum Frequency deviation
±
(2) 400~470
(3) 450~520
(4) 350~400
4W (H) / 1W(L)
2.5ppm
±
±
5kHz (W)/
3.5kHz (M)/
2.2 kHz (N)
20
Advertisement
Table of Contents
