RELM RP7200 Owner's Manual page 10

channel, either.
After exiting scanning mode and entering it again, the temporarily
deleted channel will be added in the scanning list again.
Call Forward
Press this key to enter mode.
High/Low Power Switch
"
Press the key set as High/Low Power Switch to switch between
high and low power.
Squelch Level Adjust / Check
Press and hold the key set as "Squelch Level Check"to hear
broadcast of the squelch level of the current channel.
Press the key set as "Programmable Squelch" to change
squelch level. Press once to increase one grade (cycle of 9-0;
when in level 0 a beep sounds; if the channel has not been set
with Signalling, squelch keeps long active.) and store the change.
Monitor Momentary/Call Cancel
Press the side button set as "Monitor Momentary" to turn off
CTCSS, DCS, and 5-Tone and to hear the signals that cannot be
heard when in work mode . Release the Monitor key to return to
work mode.
When in selective call state, press this key to exit selective call.
Monitor/ Call Cancel
Press the side button set as "Monitor" to turn off CTCSS, DCS,
and 5-Tone and to hear the signals that cannot be heard when in
work mode. Press again the Monitor key to return to work mode.
When in selective call state, press this key to exit selective call.
11
"
Squelch off Momentary/Call Cancel
Press the button set as "Squelch off Momentary" to open the
squelch; release it to exit.
When in selective call state, press this key to exit selective call
Squelch / Call Cancel
Press the button set as"Squelch off"to open the squelch; press
it again to exit.
When in selective call state, press this key to exit selective call
Key Lock
Press the button set as "Key Lock" to lock or unlock the keys.
Compander
Press the button set as"Compander" to switch between
compander and Normal mode.
Scrambler
Press the button set as"Scrambler" to select scrambler function
to protect communication privacy.
Battery Power Check
Press the button set as"Battery Power Check" to hear the
current power level. One, two, three or four sound to indicate
different power level separately. (One means the power is
insufficient.)
Rental Time Check
Press the button set as ¡Rental Time Check¡ and you will hear one,
two, three or four sound to indicate the rest rental time. (One
means the rental time is insufficient.)
12