Non Plug And Play System Configuration - Cabletron Systems E2210 Installation Manual

INSTALLATION
If your system is Plug and Play compatible, after you
have installed the adapter, follow these instructions:
• Power up the system and follow screen instructions. The
Plug and Play routine will automatically set the system
parameters (I/O Port, Interrupt, and DMA channel).
• If you wish to change the settings for Media, Boot Prom,
and Memory Access Speed, insert the Cabletron
distribution disk into a floppy drive and type quickset
at the system prompt. See the menu Map of QuickSet
functions on the previous page for more information.
• Install E2200 network drivers, and reboot your system.
Your E2200 series adapter is now ready for use.
2.6.3 Non Plug and Play System Configuration
If your system is not "Plug and Play" compatible, you
must run QuickSet. Follow these instructions:
To start QuickSet (Versions 2.02 and above), insert the
Cabletron software diskette, and type quickset at the
system prompt.
Use the SETUP menu selection to bring you to a
Configuration Menu containing the following three
options: Automatic Configuration, Restore Default
Configuration, and Manual Configuration. The
functionality of these options is explained briefly below:
Automatic Configuration
Automatically checks your system, and selects a
configuration based on your system's available options.
In most cases the factory default values will prove
acceptable. Conflicting I/O ports, DMA channels, or
interrupts that are in use will be changed.
Conflicting parameters will be flagged by an asterisk.
Page 2 - 12