Plug And Play System Configuration - Cabletron Systems E2210 Installation Manual

2.6.2 Plug and Play System Configuration
If you wish to run the QuickSet Configuration
! Utility, you must make sure that no E22XX network
drivers are loaded. Make sure drivers are not being
CAUTION
autoloaded by your system.
If you encounter problems running QuickSet, power
cycle your computer. You may load E22XX drivers
after configuration is completed.
Versions 2.02 (and above) of QuickSet are compatible with "Plug
and Play" personal computers. Plug and Play is most often
implemented in the computer's system BIOS or the operating
system proper (as in Microsoft Windows 95™). The QuickSet
Configuration Utility Menu Map, Figure 2-7, below, describes the
features and options of QuickSet graphically.
Automatic Configuration
Default Configuration
Find
Free
Manual Configuration
Settings
Make Changes
Plug and Play . . . . . . . . . . . . . YES
MODE . . . . . . . . . . . Standard Ethernet
I/O Port . . . . . . . . . . . . . . 300
Interrupt . . . . . . . . . . . . . . 5
DMA . . . . . . . . . . . . . . . . 3
Media . . . . . . . . . . . . . Auto Select
Boot PROM . . . . . . . . . . No Boot PROM
Memory Access . . . . . . . . . Fast
SET E22XX CONFIGURATION
SETUP
Restore
CONFIGURATION
Figure 2-7. QuickSet Menu Map
VIEW EXIT
View Only
No Changes
Save Changes
Don't Save Changes
Range of
Available
Values
Appears in
this box
* indicates
conflicting
setting
INSTALLATION
ETHERNET ADDRESS
00-00-AA-BB-CC-DD
Exit to
DOS
Prompt
Page 2 - 11