Software - Cabletron Systems E2210 Installation Manual

INTRODUCTION
E2212
The E2212 adapter connects your computer to a 10BASE-T
Ethernet unshielded twisted pair network, or to a 10BASE-2
Coaxial Thin Ethernet network via the secondary media port.
E2214
The E2214 adapter connects your computer to a 10BASE-T
Ethernet unshielded twisted pair network, or to an ST type Fiber
Optic link via the secondary media port.
E2219
The E2219 adapter connects your computer to a 10BASE-T
Ethernet unshielded twisted pair network. This adapter does not
have a secondary media port.
E221W
The E221W adapter connects your computer to a 10BASE-T
Ethernet unshielded twisted pair network, or to a wireless hub via
the secondary media port (wireless hub interface connector).
All of the E2200 series adapters use the industry standard RJ45
connector for their 10BASE-T ports.
The E2212 adapter's 10BASE-2 Coaxial port uses a standard BNC
coaxial connector, and the E2210 adapter's AUI port uses a 15-pin
industry standard type "D" connector. The E221W uses a
proprietary wireless port connector on the secondary media port.

1.3.2 Software

Software drivers for various operating systems are supplied by
Cabletron on floppy diskette media. The drivers support industry
standard Full Duplex Switched Ethernet Protocol.
The Network Software Installation Guide, which accompanies
the Cabletron software diskette, explains how to run diagnostics,
and load and configure the various network drivers supplied by
Cabletron.
Page 1 - 4