Page 2
Cabletron Systems reserves the right to make changes in specifications and other infor- mation contained in this document without prior notice. The reader should in all cases con- sult Cabletron Systems to determine whether any such changes have been made. The hardware, firmware, or software described in this manual is subject to change without notice.
Notice CABLETRON DISCLAIMS ALL WARRANTIES, OTHER THAN THOSE SUPPLIED TO YOU BY CABLETRON IN WRITING, EITHER EXPRESSED OR IMPLIED, IN- CLUDING BUT NOT LIMITED TO IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, WITH RESPECT TO THE PRO- GRAM, THE ACCOMPANYING WRITTEN MATERIALS, AND ANY ACCOMPANY- ING HARDWARE.
EMC32-12, its purpose, and an explanation of how to connect it to a module. The EMC32-12 is a twelve port RJ-45 adapter that allows up to twelve Ethernet connections to a single 50 pin champ connector, and can be used on any single Telco module.
3.) Remove the plastic cover from the Champ connection. 4.) Position RJ-45 port #1 toward the bottom of the module (See figure 1), and insert the EMC32-12 firmly into the connector. 5.) Tighten thumbscrews to ensure proper connection. Page 2...
Page 6
Figure 1: EMC32-12 Front and Rear view Length: Width: Depth: Physical 9.7 cm 3 cm 3.8 cm Physical Page 3...
Page 7
Cables and Pinout Information Cables and Pinout Information The EMC32-12 is designed to accept straight-through cabling. The RJ-45 connectors have the following configurations and pinouts: 1 2 3 4 5 6 7 8 Page 4 1. Receive + 5. Not Used 2.
If your unit fails or develops problems, contact Cabletron Systems Technical Support by: Phone: FAX: CompuServe : Internet Mail: Anonymous ftp: If you have any questions, comments, or suggestions concerning this manual, you can also contact Cabletron Technical Support at the following address or telephone number: Cabletron Systems, Inc.