Cabletron Systems E2210 Installation Manual page 3

Quick Start
To install the E2200 network adapter follow these guidelines:
1.) Turn off your computer and unplug the power cord and
peripheral equipment cables.
2.) Remove the computer cover and locate an expansion
slot. Remove the expansion slot cover.
3.) Carefully insert the adapter in the expansion slot until it
is fully seated. Secure the adapter bracket with the
expansion slot cover screw.
4.) Replace the computer cover. Connect a 10BASE-T
network cable to the adapter's RJ45 port.
Reconnect all cables and, if you are using Windows95™, power up
your computer and follow screen instructions. The operating
system will find your E2200 adapter and load the necessary
network driver (from within Windows95). Your adapter will be
ready to use. See additional steps below for other operating system
installation.
5.) If your operating system finds a configuration
parameter conflict, see Section 2.6.1, The QuickSet
Configuration Utility, for information on how to
change configuration parameters.
6.) When the system is operational, insert the Cabletron
Software floppy disk into the floppy drive.
7.) In the README directory on the software disk, locate
the README file for the network driver you need, and
proceed with network driver installation as outlined in
the README file.
8.) Reboot the computer and check that the Link LED and
the Network Activity LED are lit.
Your computer is now ready to communicate on the
network.
Page - 2