Wall Mount; Suction Mount; Clip Mount; Connect Power - Uniden BW31 Series Owner's Manual

Wall Mount

The BW3000 camera mounting clip has
two slots that fit over screws to mount
the unit on the wall.
1. Mark the position of the screw holes
on the wall.
2. Drill holes and insert the anchors and
screws provided. Be sure to leave
room for the mounting clip to fit over
the screw heads.
3. Place the mounting clip over the
installed screws and push it downwards, locking it into place.
4. Adjust the camera as needed.

Suction Mount

Clip Mount

Clip the BW3000 on ledges and shelves.
1. Press the mounting clip as shown.
2. Place the unit over the mounting surface and
release.
3. Adjust the camera as needed.

Connect Power

1. Insert the AC adaptor power plug into the camera's DC adaptor input jack.
2. Plug the other end into a 240 volt AC (standard indoor) power outlet or surge
protector. The red charging LED turns on.
3. Press POWER. The green power LED turns on and the monitor now displays
camera video. If it doesn't, try reconnecting the AC adaptor, making sure the
power outlet isn't controlled by a wall switch.
8
1. Insert the suction base into the mounting clip
as shown.
2. Firmly press the camera with the suction
base attached onto glass or metallic
surfaces.
3. Adjust the camera as needed.
# "Suctions will not stick well on a curved/
textured or wet surface. Make sure the spot
is smooth and flat. Dry the spot completely
(use a lint-free cloth, if possible).
WALL