Regulatory Notice - Black Box ServSwitch ServView 17 Series Manual

1.2 Regulatory Notice

Legal Information
Information in this document has been carefully checked for accuracy; however, no
guarantee is given to the correctness of the contents. The information in this document is
subject to change without notice. We are not liable for any injury or loss that results from
the use of this equipment.
Safety Instructions
■ Unplug equipment before cleaning. Don't use liquid or spray detergent; use a moist
■ Keep equipment away from excessive humidity and heat. Preferably, keep it in an air-
cloth.
■ When installing, place the equipment on a sturdy, level surface to prevent it from
conditioned environment with temperatures not exceeding 40º Celsius (104º Fahrenheit).
■ When the drawer is in an open position, do not cover, block or in any way obstruct the
accidentally falling and causing damage to other equipment or injury to persons nearby.
gap between it and the power supply. Proper air convection is necessary to keep it from
■ Arrange the equipment's power cord in such a way that others won't trip or fall over it.
overheating.
■
If you are using a power cord that didn't ship with the equipment, ensure that it is rated
for the voltage and current labeled on the equipment's electrical ratings label. The
voltage rating on the cord should be higher than the one listed on the equipment's
■ Observe all precautions and warnings attached to the equipment.
ratings label.
■ If you don't intend on using the equipment for a long time, disconnect it from the power
■ Keep all liquids away from the equipment to minimize the risk of accidental spillage.
outlet to prevent being damaged by transient over-voltage.
Liquid spilled on to the power supply or on other hardware may cause damage, fire or
■ Only qualified service personnel should open the chassis. Opening it yourself could
electrical shock.
■ If any part of the equipment becomes damaged or stops functioning, have it checked by
damage the equipment and invalidate its warranty.
qualified service personnel.
Regulatory Notices Federal Communications Commission (FCC)
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. Any changes or
modifications made to this equipment may void the user's authority to operate this
equipment. This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
■ Re-position or relocate the receiving antenna.
■ Increase the separation between the equipment and receiver.
■ Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
ServView 17 Enterprise KVM Drawer
2