Supermicro A+ Server AS -2014TP-HTR User Manual page 62

A+ Server AS -2014TP-HTR User's Manual
Watch Dog
JWD1 controls the Watch Dog function. The Watch Dog is a monitor that can reboot the
system when a software application hangs. Jumping pins 1-2 will cause the Watch Dog to
reset the system if an application hangs. Jumping pins 2-3 will generate a non-maskable
interrupt signal for the application. The Watch Dog must also be enabled in the BIOS. The
default setting is Reset.
Note: When the Watch Dog is enabled, the user needs to write their own application software
to disable it.
Debug Mode Enable/Disable
Jumper JDBG1 will enable or disable Debug Mode on the motherboard. See the table below
for jumper settings. The default setting is Normal Mode.
Watch Dog
Jumper Settings
Jumper Setting Definition
Pins 1-2 Reset (Default)
Pins 2-3 NMI
Open Disabled
Debug Mode Enable/Disable
Jumper Settings (JDBG1)
Jumper Setting Definition
Pins 1-2 Normal Mode (default)
Pins 2-3 Debug Mode
62