Output Data Format - Tanita WB-800AS plus Instruction Manual

en
This section covers the exporting of data from the scale to an external device (e.g. PC) using a RS-232C and USB compliant signal.
•RS-232C and USB interface are for data OUTPUT ONLY!
•This scale is not capable of receiving instructions from an external device.
Specifications
Communications standard
Communications method
ote:
•An RS-232C connector (D sub 9-pin female) and USB connector (B-type 4-pin female) are located on the back of the display unit.
•Please provide your own cables as necessary as none are included.
RS-232C :Straight D sub 9-pin (male) – D sub 9-pin (female)
USB :A-type 4-pin (male) – B-type 4-pin (male)
•Select Switch : Please select which interface you would like to use
Signal Line Name and Connection Method
Terminal no.
1
2
3
4
5
6
7
8
9
12

9. Output data format

Signal speed
Data bit length
Parity
Stop bit
Terminator
RS-232C Port
If you want to use the USB output, you must install the necessary driver on to your PC, available to download
from http://www.tanita.com
EIA RS-232C compatible
RS-232C/USB Select Switch
Signal name
TXD
GND
USB
Asynchronous transaction
9600 baud
8 bits
None
1 bit
CR+LF
US Port
5 1
9 6