Roland FJ-400 Unpacking, Assembly And Installation Manual page 9

Place the media guide on the stays and secure it in place using the included small bolts.
5
Media guide
Pass the media flanges onto the retainers and
6
secure in place with the flange retaining pins.
Orient the media flange so that it's lined up with
the core diameter of the loaded roll material.
2 in.
Set the media cover in place on the pins at the back of the machine shown in the figure.
7
Remove the bottom plug from the bottom surface
8
on the right side of the machine, then screw in the
drain bottle in the direction indicated by the
arrow. When threading the bottle onto the
machine, turn the bottle without applying
excessive force.
Leave the drain bottle attached at all times,
removing it only when moving the machine or
disposing of collected ink.
8
Bolts (Small)
3 in.
Orientation of the media guide
Media
guide
* If the short side is oriented
toward the back of the machine,
roll material may fall.
Media flanges
1)
Line up the ridges
and grooves.
Left-hand side of
the back of the unit
Flange retaining pins
2)
Media cover
Drain bottle
Rear Front
Long Short
Retainer
1)
Right-hand side of
the back of the unit
30%
2)
* The bottom plug is needed
when moving the machine,
so do not discard it.
Bottom plug
Remove the bottom plug by
pulling straight down,
without tilting the plug.
Otherwise discharged fluid
that has collected inside the
bottom plug may spill.