NetApp FAS8200 Manual page 71

If the system-level diagnostics
tests...
Were completed without any
failures
Resulted in some test failures
Recable the system and reassign disks - FAS8200
Continue the replacement procedure by recabling the storage and confirming disk
reassignment.
Step 1: Recable the system
After running diagnostics, you must recable the controller module's storage and network
connections.
Steps
1. Recable the system.
2. Verify that the cabling is correct by using
a. Download and install Config Advisor.
b. Enter the information for the target system, and then click Collect Data.
Then...
a. Clear the status logs:
b. Verify that the log was cleared:
The following default response is displayed:
SLDIAG: No log messages are present.
c. Exit Maintenance mode:
The system displays the LOADER prompt.
You have completed system-level diagnostics.
Determine the cause of the problem.
a. Exit Maintenance mode:
b. Perform a clean shutdown, and then disconnect the power
supplies.
c. Verify that you have observed all of the considerations identified
for running system-level diagnostics, that cables are securely
connected, and that hardware components are properly installed
in the storage system.
d. Reconnect the power supplies, and then power on the storage
system.
e. Rerun the system-level diagnostics test.
Active IQ Config Advisor.
sldiag device clearstatus
sldiag device status
halt
halt
69