Changing The Access Level 2 Entry Code; Access Level 1 And 2 Menus Structure - C-TEC XFP501E/CA User Manual & Log Book

CAST XFP 16 & 32 ZONE ANALOGUE ADDRESSABLE FIRE ALARM PANEL

Changing the access level 2 entry code

This function allows you to change the four digit code needed to enter the panel's access level 2 menu
options.
AL2 (3333) > Change Access Level 2 Code
When selected, press the Accept
Enter NEW Access Level 2 Code
5 4
Using the (1),
the fourth digit has been entered, the panel will request you confirm the new code by re-entering it.
Enter NEW Access Level 2 Code: ****
Confirm NEW Access Level 2 Code:
Enter the code again by pressing the
codes match, the panel will accept the code and you will be taken back to access level 2. If you type an
incorrect confirmation code you will be prompted to start the new code entry sequence again.
BE SURE TO KEEP A RECORD OF THE NEW CODE ON PAGE 20 OF THIS USER MANUAL.
Fig.3 : CAST XFP Access Level 1 and 2 Menu structure
Menu button
(model dependent)
AL1
ENTER ACCESS LEVEL 2
ENTER ACCESS LEVEL 3
DISPLAY FIRE EVENTS *
DISPLAY FAULT EVENTS *
DISPLAY DISABLEMENTS *
DISPLAY ZONES IN TEST *
LAMP TEST
DISPLAY ALARM COUNTER
AL2 CODE
ENTRY
AL2
ENTER ACCESS LEVEL 3
DISPLAY FIRE EVENTS *
DISPLAY FAULT EVENTS *
DISPLAY DISABLEMENTS *
DISPLAY ZONES IN TEST *
LAMP TEST
DISPLAY ALARM COUNTER
SET TIME/DATE
EVENT LOG FUNCTIONS
SET/CLEAR DISABLEMENTS
CHANGE ACCESS LEVEL 2 CODE
USER MANUAL & LOG BOOK • Approved Document No. DFU5020000 Rev 3 • Page 19 of 24
4
button and the following window will appear:
6 3
(2), (3), (4) buttons, enter the new four digit access level 2 entry code. After
5
(1),
AL2 K/S
ENTRY
4 6 3
(2), (3), (4) buttons in same sequence. If the two
AL1 - ACCESS LEVEL 1
AL2 - ACCESS LEVEL 2 (Code 3333)
* THE MENU OPTION SHOWN WILL ONLY BE
AVAILABLE IF RELEVANT TO THE PANEL'S STATUS.
MENU NAVIGATION
PRESS ACCEPT BUTTON TO MOVE FORWARD.
PRESS ESCAPE BUTTON TO MOVE BACK.
PRESS SCROLL BUTTON TO MOVE UP.
PRESS SCROLL BUTTON TO MOVE DOWN.
Total Alarms = nnn
Alarms Since nn/nn/nn = n
KEYSWITCH (K/S)
(model dependent)
Total Alarms = nnn
Alarms Since nn/nn/nn = nn
PRINT EVENT HISTORY
DISPLAY EVENT HISTORY
RESET EVENT HISTORY
ENABLE/DISABLE ZONES
ENABLE/DISABLE SOUNDERS
ENABLE/DISABLE OUTPUTS
ENABLE/DISABLE RELAYS
ENABLE/DISABLE DEVICES
ENABLE/DISABLE FAULT RELAY
ENABLE/DISABLE OUTPUT DELAYS
Clear to todays date?
Alarms Since nn/nn/nn = nn