Cause And Solution Of Problems - Clay Paky MYTHOS2 Instruction Manual

THE PROJECTOR WILL NOT SWITCH ON
ELECTRONICS NON-OPERATIONAL
DEFECTIVE PROJECTION
POSSIBLE CAUSES
REDUCED LUMINOSITY
No mains supply.
Lamp exhausted or defective.
Signal transmission cable faulty or disconnected.
Incorrect addressing.
Fault in the electronic circuits.
Lenses or reflector broken
Dust or grease deposited.
MYTHOS MYTHOS 2

CAUSE AND SOLUTION OF PROBLEMS

Check the power supply voltage.
Replace the lamp. (See instructions).
Replace the cables.
Check addresses (see instructions).
Call an authorised technician.
Call an authorised technician.
Clean (see instructions).
14
PROBLEMS
CHECKS AND REMEDIES