Power On Procedure - Fujitsu ETERNUS DX60 S2 Hardware And Software Installation Manual

Power On Procedure


Power on ETERNUS from Controller Enclosure

Push the Power Switch

If everything is OK, the READY LED will go green in about three minutes

LEDs
POWER
• Green when the power is turned on
READY
• Green when the system is available for use
FAULT
• Steady orange when a malfunctioning system
component has been detected
• Blinking orange when a preventive replacement of
a system component is required
IDENTIFY
• Blinking blue when turned on from the
management software
CACHE
• Steady green when the cache is in use
• Blinking green when a power failure has occurred
and the cache data has been stored in the
CompactFlash memory
Hardware and Software Installation ETERNUS DX60 S2 13 Copyright Fujitsu Technology Solutions, Release September 2011