Nice ROBO600 Instructions And Warnings For Installation page 21

7.3.2 - "Remote" memorisation
You can memorise a new transmitter without having to operate the receiver key (10-20 m from the receiver).
You must have a previously memorised transmitter (old). The new transmitter will be memorised with the same characteristics as the old one.
Important! Remote memorisation may be done on all receivers within the range of the transmitter; therefore, only the one
involved in the operation should be kept switched on.
Standard procedure
During the procedure, if the old transmitter was memorised in:
- Mode 1 ¨ press any key
- Mode 2 ¨ press the key you wish to memorise
01. With the motor stopped, stand close to the control unit
NEW
02.
transmitter
OLD
previously
03.
memorised
transmitter
NEW
04.
transmitter
If the procedure terminated successfully the new transmitter is
memorised
* same key as NEW transmitter
The RADIO LED can also perform the following:
1 rapid flash if the transmitter is already stored, 6 flashes if the transmitter's radio coding is not compatible with that of the control panel receiver
or 8 flashes if the memory is full.
7.3.3 - Deleting radio transmitters
This procedure can be carried out ONLY if the radio memory is unlocked.
Table 10
Transmitter deleting procedure
1
Hold down the RADIO key
2
Wait for the radio led R to come on, then wait for it to go off and
finally wait for 3 flashes
3
Release the key during the 3rd flashing
If the memorisation has been successful, the radio led R on the
control unit flashes 5 times
*
x 5s
x 1s x 1s
*
x 1s
on the control unit until step 02
Alternative procedure
During the procedure, if the old transmitter was memorised in:
- Mode 1 ¨ press any key
- Mode 2 ¨ press the key you wish to memorise
01. With the motor stopped, stand close to the control unit
NEW
02.
transmitter
OLD
previously
03.
x 1s
memorised
transmitter
NEW
04.
transmitter
OLD
previously
05.
memorised
transmitter
If the procedure terminated successfully the new transmitter is
memorised
* same key as NEW transmitter
** same key as OLD transmitter
*
x 3s
**
x 3s
*
x 3s
RADIO LED
**
x 3s
not visible
at a distance
= RADIO key = RADIO led
English – 19