Nice QUICK START INSTALLATION GUIDE Quick Start Installation Manual

QUICK START
INSTALLATION
GUIDE
ACTUATOR AND CONTROL BOX INSTALLATION:
Weld or clamp pivot arm on gate hinge post for Pull-to-Open (left) or Push-to-Open (right).
E X T R E M E LY
IMPORTANT!
1A
Read entire
manual before
attempting the
installation.
This is NOT a
"do-it-yourself"
project. Use a
qualified con-
tractor to install
this system.
Read all safety
information!
CAUTION! Do NOT weld while control board is powered!
2
1/2"x3.5"
BOLT
Attach Actuator
to Pivot Arm
PIVOT ARM
FIGURE 1: INSTALLATION OF ACTUATOR TO PIVOT ARM AND GATE BRACKET
Ensure actuator arm is fully retracted, then position gate
4
bracket on gate structural support as shown below:
GATE OPEN
PULL-TO-OPEN:
Fully open gate,
then locate bracket
Pull-To-Open
on gate support.
PUSH-TO-OPEN:
Fully close gate, then
locate bracket on
gate support.
7 Manually Set Limits:
With actuator mechan-
ical release open, manually
push gate to desired close
limit, then push to desired
open limit, and then push
to halfway open position.
Close mechanical release,
but do not lock.
CAUTION! Do not mount the control box where the person using
the push button on box can come in contact with the gate!
MX4816-01 Rev. B ©2020
PIVOT ARM: Pull-To-Open
HINGE
HINGE
GATE
GATE BRACKET CENTERLINE
POST
1/2"
13"
TOP OF
PIVOT ARM
6"
TOP VIEW FRONT VIEW
ENSURE
LEVEL
LOCK
NUT
Bracket Position
GATE CLOSED
Push-To-Open
Bracket Position
8 Mount Control
same side as primary
actuator and minimum six feet
away from pivot arm (See FIG-
URE 2).
Place Battery inside
9
control box with ter-
minals facing toward the front.
TITAN12L, 912L (w/936)
1B
HINGE
POST
6"
Pivot
Arm
GATE
GATE
BRACKET
912L ACTUATOR
5
Affix Gate
Bracket to
gate struc-
tural support
by welding
or using
bolt/nut.
10
Box Wire
control board: Pass
cable through rubber grom-
mets in bottom of control
box and wire per diagram
at right.
For dual gate, dig trench
across drive and run 2nd
actuator cable through con-
duit.
NOTE: Dual gate: wire Motor 1 and Motor 2 the same way.
Swing Gate System
PIVOT ARM: Push-To-Open
HINGE
GATE BRACKET CENTERLINE
GATE
1/2"
11"
Top of Pivot Arm
TOP VIEW FRONT VIEW
3
Attach Actuator to
Gate Bracket
6
Open mechanical release on actuator.
1 2
Pull-To-Open
actuator to
Black Red
hysecurity.com • 800-321-9947
Pivot Arm
1/2"x
2-7/8"
PIVOT
BOLT
WASHERS
LOCK NUT
3
Push-To-Open
Red Black
1