Product Description And Intended Use; Operating Limits - Nice ROBO600 Instructions And Warnings For Installation

1

PRODUCT DESCRIPTION AND INTENDED USE

ROBO is an electromechanical gearmotor intended for automating residential sliding gates: it is equipped with an electronic control unit with
integral 433.92 MHz radio receiver with O-CODE coding.
CAUTION! – All uses other than the intended use described and use in environmental conditions other than those described in
this manual should be considered improper and forbidden!
The essential characteristics of the ROBO gearmotor are described in Table 1.
Gate limit (m)
Weight limit (kg)
Power (V~)
Nominal power (W)
Peak thrust (Nm)
corresponding to force (N)
Rated torque (Nm)
corresponding to force (N)
Work cycle (cycles / hour)
Notes: 1 kg = 9.81N (example: 600N = 61 kg)
2
APPLICATION LIMITS
The effective suitability of ROBO to automate a particular sliding gate depends on the friction as well as other correlated factors, such as ice, that
could interfere with the movement of the gate.
Measure the force required to move the gate through its entire stroke and check that this does not exceed 25% of the 'maximum force' (chapter
13 - technical specifications): this leaves a suitable margin for unfavourable climatic conditions which can increase friction.
Gate width (m)
Up to 4
4 ÷ 6
6 ÷ 8
8 ÷ 10
10 ÷ 12
Caution! Any other use or use with dimensions greater than specified is non-conforming. Nice declines all liability for damage
and injury resulting for non-conforming use.
Table 1 – Essential characteristics
Table 2 – Application limits
max No. of cycles / hour
40
25
20
-
-
ROBO600
8
600
230
300
18
600
9
300
20
ROBO600
max No. of consecutive cycles
20
13
10
-
-
English – 3