Section 3, Installing The Exhaust System; Before You Begin - ITR Oasis® Zephyr ™ Oasis Zephyr HW Installation And Operating Manual

Installing the Exhaust System
! DANGER
International Thermal Research
3.1

Before You Begin

For efficient and safe operation of the Oasis® Zephyr™ HW follow
all recommendations for properly installing the exhaust.
deviations from these recommendations must be approved in
advance by ITR.
Although the heater's exhaust produces very low carbon monoxide
emissions, caution is advised:
· Do not operate the Oasis® Zephyr™ HW in an enclosed area
unless there is adequate ventilation.
· Isolate the Oasis® Zephyr™ HW in a closed compartment. Air
from this compartment must be allowed infiltrate any living
areas of the vehicle.
Heater exhaust can reach high temperatures; never install exhaust
parts close to combustible materials or through a combustible wall
or ceiling without fireproof protection. Heater exhaust must be
directed to the outside of the vehicle away from windows, inlet
vents, and slider-outs. The heater exhaust system must be installed
following all specific RVIA standards.
Section
3
Any
3-1