TEC B-370 Series Maintenance Manual page 55

6. DIAG. TEST OPERATION
6.3.6 Character Code Selection
< 1 >
D I A G N O S T I C
< 2 >
P A R A M E T E R
Press the [PAUSE] key seven times.
F O N T
Select either character code with
the [FEED] key or [RESTART]
key. (See NOTE 1.)
NOTES: 1. Holding the [FEED] key or [RESTART] key down for more than 0.5 seconds enables
a fast forward.
2. A changed font code is stored in memory by pressing the [PAUSE] key.
Power off
Turn on the power while
holding down the [FEED]
key and [PAUSE] key.
Press the [FEED] key.
S E T
C O D E
Press the [FEED] key
and [RESTART] key
at the same time.
V 1 . O A
P C - 8 5 0
• PC-850
• PC-8
Press the [PAUSE] key.
Continued on Section 6.3.7
Font zero selection.
6-25
EM18-33012
6.3 PARAMETER SETTING MODE