TEC B-370 Series Maintenance Manual page 22

3. INSTALLATION PROCEDURE FOR THE OPTIONAL EQUIPMENT
7. Remove the motor cover. (See Fig. 2-9.)
8. Disconnect the connector from CN2 on the PWM PC board.
9. Clamp and pass the cable through the opening and connect it to the CN1 on the Cutter I/F PC board.
CPU PC Board
Opening
10. Install the cutter unit with the attached screws (cutter attaching screw, FL-4x6).
When installing the cutter, make sure that the cutter guide is not in contact with the platen. If it is, print
failure or noise may be caused.
PWM PC Board
Connector (CN2)
Clamp
Clamp
Opening
Connector (CN1)
Cable
Cable
3-4
SVO7A1003: Nov. 21 '97
3.2 CUTTER MODULE (B-4203-QM)
Fig. 3-5
Cut I/F PC Board
Cutter Unit
Fig. 3-6
Fig. 3-7
EM18-33012