Toshiba BU Series Instruction Manual page 48

- Open/Close stream channel (to be ready to receive stream data)
Set "1" to "StreamEnable" in Bootstrap Registers before "ImageBufferRead".
Set "0" to "StreamEnable" in Bootstrap Registers after completion of image acquisition from image buffer.
- Capture and store images
Input trigger signals to capture and store images.
"ImageBufferFrameCount" register shows the number of frames stored in the buffer.
The maximum number of frames storable depends on the image size. (maximum 256MByte.)
- Set the number of frames to transfer (In ImageBuffer mode)
Set the number of frames to transfer to "AcquisitionFrameCount". Setting value is Integer type.
- Read images from the buffer
Read the number of AcquisitionFrameCount image(s) from the buffer by executing "ImageBufferRead"
register command (it is equivalent to write value 10 to "AcquisitionCommand" register).
● Note
When opening and closing the stream channel, it is required to control StreamEnable plus SDK setups on
your application. Please refer to the TeliCamSDK for details.
[Start] button in TeliU3vViewer can't deal with "StreamEnable" register alone.
Please substitute procedure "StreamEnable" = 1 to following instructions.
- Push [Start] button
- Execute [AcquisitionStop] in XML window.
Copyright © 2016 – 2019 Toshiba Teli Corporation, All rights reserved.
on TeliU3vViewer main window.
47 / 80
http://www.toshiba-teli.co.jp/en/index.htm
D4256843D
xB