Appendix; Usersetsave And Usersetquicksave Difference - Toshiba BU Series Instruction Manual

UserSetSave and UserSetQuickSave difference

If you want to change multiple Camera Settings (e.g. ROI setting) at once, UserSet feature is useful.
Application needs to save the camera settings in UserSet memory in advance or in initialization stage.
By UserSetSave, UserSet is stored to non-volatile flash memory.
It takes about 700ms to execute UserSetSave because Non-volatile flash memory needs to be erased
before writing. If you want to switch over multiple different settings in run time, overhead time of UserSetSave
is inevitable.
Application
700ms
Camera
Exposure
Image
Streaming
On Interface
Bus
Copyright © 2016 – 2019 Toshiba Teli Corporation, All rights reserved.

Appendix

Overhead
Apply
#1
- ImageSize
- ExposureTime
- Gain
- ...
FPGA
Apply
#2
UserSet #1 UserSet #2
Frame #1
Tact Time
Overhead
Save
UserSet1
UserSet1
UserSet
Serial Flash
74 / 80
UserSet have to be loded after
Completion of Image Reception
Apply
#3
UserSet #3
Frame #2 Frame #3
D4256843D
http://www.toshiba-teli.co.jp/en/index.htm
xB