Advertisement
This product is not provided with cord and plug or with other means for connection from the supply. When connect
or change the power cord or lead wire, it must be replaced by the competent personnel in order to avoid hazard.
Please use 227IEC53(RVV) or thickness of tube is 1mm or above. (Other requirements such as diameter of lead
wire, please use according to the regulation of the country).
本產品不提供電纜和插頭或連接電源的其他裝置。當連接或更換電纜或電線時必須由能胜任的人員進行以避免危險。
請使用227IEC53(RVV)或厚度超過1毫米的導管。（其他要求，例如電線直徑等等，請遵守相關國家的條例）。
This product should be installed with a double poles single throw switch (Breaker Switch) with minimum 3mm
contact gap in the fi xed installation circuit.
Do not connect this Ceiling Fan to dimmer switch or regulator. (It can damage the Ceiling Fan)
此產品必須在固定安裝電路上裝上觸點間隙為最少3毫米的雙極單投開關（斷路開關）。
切勿將此吊扇連接至調光開關或調節器。（這會損壞吊扇）
Should there be a dimmer switch or regulator, disconnect it and reconnect the wiring as below.
若有調光開關或調節器，請按照下圖拆除然後重新連接。
Regulator /
調節器
It is recommended to user, to install an OFF/ON switch on the wall for the Ceiling Fan, replacing existing regulator or new
regulator point. If your Remote Control missing or misplaced, the Ceiling Fan can be switched on at pre-set speed 2.
建議用戶將吊扇的 OFF/ON 開關安裝在牆壁上，替換現有的調節器或新的調節點。若您的遙控器不見了，吊扇可以以預設速
度 2 開啟。
Check Point After Installation / 安裝後的檢驗點
1. The wiring is connected properly to the power supply.
電線已正確地連接了電源。
Regulator / 調節器
Power Supply / 電源
Connect Directly /
直接連接
ATTENTION / 留意
CAUTION / 注意
Dimmer Switch / 調光開關
Power Supply / 電源
Connect Directly /
直接連接
Dimmer Switch /
調光開關
留意
11
Check / 檢查
Advertisement
