Table of Contents
Advertisement
Operation
→ Changed by repeatedly pressing
the corresponding button on the
remote or the unit.
• Cycles through the different
preset ambient lighting settings
of the unit, this includes different
combinations of colours of the
flame base and media lighting.
! NOTE: The last theme of the
cycle is a prism where the unit
cycles through a variety of colours.
Pressing the
cycling and holds the unit on the
preferred color, indicated by a "U"
- Unfreeze or a "F" - Freeze on the
display.
G.
Brightness
Changes the brightness of the
lights in the unit.
→ Adjusted by repeatedly pressing
the corresponding button on the
remote.
• Indicated by the second digit on
the Floating Display™ changing
to show: "H" (high), and "L" (low).
button stops the
H.
Sleep Timer
The Sleep Timer can be set to
automatically shut off the fireplace
after a preset time (from 30 minutes
to 8 hours).
→ To set the timer press the
timer button on the remote,
repeatedly, until the desired time
is displayed.
• The Floating Display
display the different times as it
is adjusted. Once the timer has
begun, pressing the
will display the time remaining
before the unit turns Off.
! NOTE: The Sleep Timer can be
cancelled at any time by pressing
the
button repeatedly until the
sleep timer displays nothing.
Resetting the Temperature
Cutoff Switch
Should the heater overheat, an
automatic cut out will turn the whole
unit off and it will not come back
on without being reset. It can be
reset by turning the unit off at the
main disconnect panel and waiting
5 minutes before turning the unit
back on.
will
TM
button
17
Advertisement
Table of Contents
