First Steps; Charge Device; Power On/Off - Philips VoiceTracer DVT4010 User Manual

4 First steps

Use the installation guide on the following pages to start using your
device quickly and easily.
Caution
• Follow the instructions on handling the device, especially the
batteries and rechargeable batteries
Batteries and rechargeable batteries, page

4.1 Charge device

Note
• Connect the device to a computer or use an external battery
charger.
• Fully charge the device before first use.
• A complete charging cycle takes about 3.5 hours. The computer
must be turned on when charging the batteries. If the USB port
of the computer does not supply enough power, use an external
battery charger.
1
Plug the USB connector into a USB port on your computer.
2
Insert the micro USB plug into the USB port on the bottom of the
device.
Table of contents
(see also chapter 1.1.1
5).

4.2 Power on/off

1
Slide the on/off switch on the side of the device downwards for
approximately two seconds.
The device turns on and the start-up screen is displayed.
X
2
To power off, pull down the power switch on the side of the device
again and hold for about two seconds.
15
First steps