Advertisement
Drill a ¼" hole in the drain pipe
above the trap and on the ver-
tical or horizontal tail piece. Lo-
cate the drain connection away
from the garbage disposal to
prevent potential contamination
and system fouling.
4. Install water storage tank and mount tank valve.
5. Remove gags and connect tubes as follows. See the connection chart for details.
Insert filtered water tubing from the "faucet" outlet fitting of the R.O. filtration unit into the fau-
■
cet using insert, sleeve and compression nut. See faucet installation chart for deta ls.
3/
never
mount
here
Insert water supply tubing from inlet valve adapter into the "inlet"
■
fitting of the R.O. filtration unit.
Connect with the tubing the "tank" outlet fitting of the R.O. filtration
■
unit with the tank valve fitting.
Insert the waste tubing from the "waste water" outlet fitting of the
■
R.O. filtration unit into the drain saddle (through the optional union
check valve on the way) or to a waste water collection container. Install
the check valve with the arrow in the direction of flow.
Tank is a clean water storage container.
Never place the tank in direct sunlight or
near the sources of heat. It's recommended
to have the tank been installed near the R.O.
filtration unit and the faucet.
mount tank valve on the inlet-outlet port of
the tank. Use some Teflon or plumbers seal-
ing tape to prevent leak.
mount drain
saddle here
never mount
here
m un dra n
n
t
11
Advertisement
