Commissioning, Inspec-Steps - Commissioning, Inspection And Maintenance - Viessmann B0KA Installation And Service Instructions Manual

Steps - commissioning, inspection and maintenance
Commissioning steps
Inspection steps
Maintenance steps
•
1. Commissioning the system............................................................................................... 30
• •
2. Filling the heating system................................................................................................. 32
• • •
3. Checking all connections on the heating water and DHW sides for leaks................... 34
•
4. Venting the heating system............................................................................................... 34
•
5. Checking the gas type....................................................................................................... 34
• • •
6. Removing the front panel.................................................................................................. 35
• • •
7. Checking the static pressure and supply pressure........................................................ 36
•
8. Function sequence and possible faults........................................................................... 37
•
9. Setting the maximum heating output............................................................................... 38
• •
10. Performing an actuator test.............................................................................................. 38
•
11. Adjusting pump rate of integral circulation pump.......................................................... 38
•
12. Leak test on balanced flue system (annular gap check)................................................ 40
• 13. Burner adjustment when connecting multiple flues to a shared flue system.............. 40
•
14. Removing the burner......................................................................................................... 41
• •
15. Checking the burner gasket and burner gauze assembly.............................................. 42
• •
16. Checking and adjusting the ignition and ionisation electrodes.................................... 43
• •
17. Checking the back draught safety devices...................................................................... 43
•
18. Cleaning the heating surfaces.......................................................................................... 44
• •
19. Checking the condensate drain and cleaning the trap................................................... 44
• •
20. Installing the burner........................................................................................................... 46
• •
21. Checking the neutralising system (if installed)
•
22. Checking the flow limiter (only for gas condensing combi boiler)............................... 47
• • •
23. Checking the expansion vessel and system pressure................................................... 47
• • •
24. Checking the safety valve function
• • •
25. Checking the electrical connections for firm seating..................................................... 48
• • •
26. Checking all gas equipment for leaks at operating pressure........................................ 48
• • •
27. Fitting the front panel........................................................................................................ 48
• •
28. Checking the combustion quality..................................................................................... 49
• • •
29. Checking the flue system for unrestricted flow and leaks
•
30. Matching the control unit to the heating system............................................................ 50
•
31. Adjusting the heating curves............................................................................................ 50
•
32. Instructing the system user.............................................................................................. 50
Commissioning, inspection, maintenance
Page
29