Table of Contents
Advertisement
Pull the factory installed wires out of the top of the
stove. There will be two wire harnesses, as shown.
Connect the factory installed wiring harnesses to the
control panel as shown.
PANEL CONTROLS
The blowers and automatic fuel supply are controlled from a panel on the top of this unit. The control panel
functions are a follows.
A. ON/OFF SWITCH ("POWER" BUTTON)
•
When pushed, the stove will automatically ignite. No other fire starter is necessary. The igniter will stay on
for at least 10 and up to 12 minutes, depending on when Proof of Fire is reached. The fire should start in
approximately 5 minutes.
•
The red light located above the "POWER" button will turn green when pressed and remain green until
the stove is turned off.
•
After pushing "POWER", the auger motor is on for 3.5 minutes, off for 1 minute. During the remainder of
the start-up period, the auger motor operates on the heat range "1" setting.
•
During start up the heat level advance (Up and Down keys) will change the heat range indicator level
accordingly, but there is no change in the stoves operating conditions until start-up is completed.
•
During start-up ignition must occur within 12 minutes or the stove will error out and show E4.
•
During the start-up phase, the Mode key does not function.
B. LEVEL / TEMP ARROW BUTTONS
•
These buttons when pushed will set the pellet feed rate, hence the heat output or heat range of your
stove.
•
The levels of heat output will incrementally change on the bar graph starting from heat range "1" to heat
range "5".
C. °C / °F Button
•
The °C / °F button changes the two digit display from degrees Celsius to degrees Fahrenheit.
Assembly Instructions
Step 1
Step 3
Control Panel
Unpack the top mount controls and ensure that the
wiring harness shown is attached securely.
Attach the control panel to the top of the stove, as
Secure with two sheet metal screws.
-8-
Step 2
Step 4
shown.
Step 5
Advertisement
Table of Contents
