Yamaha SX500D Supplementary Service Manual page 110

Fasten the wire harness and start-
1
er cable with a plastic clamp.
Route the wire harness and
starter cable through the slot on
the intake silencer.
CDI unit
2
Carburetor switch coupler
3
Water temperature sensor coupler
4
Starter relay coupler
5
CDI unit
6
Make sure a plastic-locking tie is
7
routed through wire harnesses
as shown.
CDI unit coupler
8
Fasten the wire harness with a
9
plastic clamp.
Route the wire harness through
the slot on the intake silencer.
Clamp
10
Does no kink.
CDI magneto coupler
11
Starter relay coupler (without
12
electric starter model)
Clamp
13
Coolant breather hose
14
To the coolant reservoir tank
15
CDI unit coupler
16
To the conduction
17
Wire harness
18
CABLE ROUTING
–106–
SPEC