Test Read Card After Update - Promag Mifare DESFire DF7 Series User Manual

PROMAG

4.2 Test Read Card After Update

The following steps indicate you to test read card:
1. After set configurations in the Reader Utility software, you can click [Update Reader] to update
the currently configurations to the reader.
2. Or, click [Test] to update configurations and verify output data.
3. Got an issued Mifare card and approach the reader, you can see the output data on "Reader
Test" window.
Wiegand 34 bits output data with standard bit sequence, example as below:
Remark:
1. When using reader-kit to test Wiegand (or TK2) signal, this test may be failed if the processor of computer is too slow.
2. When using reader-kit to test Wiegand (or TK2) signal, you need to connect to the physical COM port.
35
DF7XX
REV.E