PROMAG
4.1 Reader Test
After reader's configurations have been updated success, you can use [Test] function to check reader's
configurations have been correctly stored.
LED [0]~[9]:
(default=Disable)
Manually to control LED/buzzer by commands [0]~[9]. Enable this by "Enable RS232 Command Set Control".
Buffering: (default=Disable)
Manually to control data output timing by the command [Buffering Data].
Enable this by "Buffering" Enabled.
Relay:
(default=Disable)
Not available for DF7XX readers.
Available
COM ports.
34
DF7XX
Use to "decode
with parity"
when Wiegand
interface not
with parity.
Click to clear
the output data,
or double click
the output area.
Click to
re-connect
COM port.
REV.E