Replacing The Track - Zodiac CyclonX EM14 Series Owner's Manual

3. Position the new brush matt underneath the
roller with the bristles facing downwards. Refer
to Figure 16.
Figure 16. Position the New Brush on Roller
4. Thread each tab into the slot provided and
gently feed it through until the heel comes out
at the other side of the slot. Refer to Figure 17.
4
Figure 17. Pull Tabs Through Each Slot
5. Use scissors to cut the tabs at the guides, as
shown in Figure 18.
Figure 18. Cut Tabs
6. Repeat this procedure to replace the second
brush matt.
4.3

Replacing the Track

1. Stand the cleaner on its side (Figure 19).
Figure 19. Stand Cleaner on its Side
2. Starting at one of the wheels, pull on the inside
of the track to separate the tire lip from the
wheel. See Figure 20. Remove the track from
the cleaner.
Figure 20. Pull the Track Over Wheels to Remove
3. To install a new track, place the inside rib of
the track into the groove in the fi rst wheel. See
Figure 21.
1
Figure 21. Position Track into Wheel Grooves
4. Stretch the track around the second wheel, then
pull over the last wheel (see Figure 22). Push
and position the rib of the track so that the track
is seated properly in the groove of the wheel.
H0446500_REVB
11