Page 1
Installation Instructions 50’ Century Tent ® Single or Double Center Pole Non-Certifi ed Installation Double Center Pole Illustrated See inside this manual for proper staking. Illustration is for concept purposes only. Please read all assembly / installation instructions before the installation or removal of this product.
Index Introduction ......................3 Safety Notes........................ 3 Manpower/Tools Required ....................4 Parts Illustrations ......................4 Web Guy Layout - Single Center Pole .................5 Web Guy Layout - Double Center Pole ................ 6 Web Guy Layout - Single Center Pole - (Round End) ..........7 Staking Guidelines ......................7 Layout at Site ......................7 Lacing Instructions .....................8...
Introduction The installation of this Century Tent should be performed/supervised by knowledgeable tent installers with a clear under- standing of safety issues as well as the methods of anchoring. The requirements as specified with blue print (supplied by Anchor Industries Inc.) must be followed. The installer/owner must read the assembly instructions completely prior to any installation.
IMPORTANT: The requirements as specified with blue print (supplied by Anchor Industries Inc.) must be followed. Particular atten- tion should be made to anchoring system. MANPOWER REQUIRED LAYOUT & CHECK Four experienced installers should be able to assemble a Utilize parts list for a quick I.D. and a check list to 50’...
THE INSTALLER MUST USE THE LOCAL SOIL CONDITIONS TO CALCULATE THE ACTUAL NUMBER OF STAKES REQUIRED AND IS RESPONSIBLE FOR THE STAKING PATTERN AND CONFIGURATION. ANCHOR PROVIDES ANCHORING PACKAGES FOR COMMON SOIL CLASSIFICATIONS; CONTACT YOUR TENT SALES REPRESENTATIVE FOR MORE INFORMATION.
THE INSTALLER MUST USE THE LOCAL SOIL CONDITIONS TO CALCULATE THE ACTUAL NUMBER OF STAKES REQUIRED AND IS RESPONSIBLE FOR THE STAKING PATTERN AND CONFIGURATION. ANCHOR PROVIDES ANCHORING PACKAGES FOR COMMON SOIL CLASSIFICATIONS; CONTACT YOUR TENT SALES REPRESENTATIVE FOR MORE INFORMATION.
Single Center Pole, Round End Layout See Staking Table for Single Pole on page 5 for Round End Staking MARK LOCATION OF STAKES, SIDE POLES & CENTER POLES Quantities. (2) WEB GUYS WITH 4’ STAKE BAR AND (6) 42” DBL.
3 LACING INSTRUCTIONS With tent sections on ground, overlap cen- MIDDLE ter pole holes with grommet side on top. Lace between center pole holes first. Push CENTER POLE first loop up through corresponding grom- HOLE met. Continue, passing each loop through a grommet and the preceding loop.
Adjust bases of poles to exact location and align poles vertically. CAUTION: At this point, it is JUMP ROPE required to properly anchor bases of all center poles to prevent movement.
8 WINCH FOR TENSION If the footprint of the tent has been laid CAUTION: out properly and the tent placed squarely KEEP TO SIDE OF WINCH WHEN TENSIONING. DO within that footprint, the following tension- JUMP NOT EXTEND LENGTH ing sequence is recommended for the best OF WINCH BAR TOOL.
Page 11
Regardless of the number of stakes we suggest, we make no representation or warranty as to whether this speci c number of stakes will meet the local tent code. Anchor does not, nor can it make any suggestions, representation, or warranties about the adequate staking required at each speci c installation site.
Need help?
Do you have a question about the Century and is the answer not in the manual?
Questions and answers