Subscribe to Our Youtube Channel
Related Manuals for Anchor ETI 30’CLASSIC FRAME TENTS
Summary of Contents for Anchor ETI 30’CLASSIC FRAME TENTS
- Page 1 30’ ASSEMBLY INSTRUCTIONS CLASSIC FRAME TENTS 2995 NW 75th Street, Miami, FL 33147-5943 • 305-691-0191 • 800-438-3226 TOLL FREE: sales @economytent.com • economytent.com EMAIL: WEB:...
-
Page 2: General Care And Maintenance
SAFETY BEST PRACTICES STAKING / ANCHORING BASICS Economy Tent International products are of superior design By law you are required to contact your local “Call before you and function best in the parameters of these instructions. It dig” number before you plan to dig or drive tent stakes for your is recommended that the instructions are carefully read and local utility company to mark the location of all underground followed. - Page 3 30’ ASSEMBLY INSTRUCTIONS CLASSIC FRAME TENTS TUBING, FITTING, EQUIPMENT LIST 30’ TUBING 30’ FITTINGS • 9’4” Side Eave Bar • 9’4” Top Bar • 14’4” Side Eave Bar • 16’ Mid Rafter Bar • 21’8” Double Tube Corner Rafter Bar 6-Way Crown Top Extension Corner...
- Page 4 30’ ASSEMBLY INSTRUCTIONS CLASSIC FRAME TENTS EAVE ASSEMBLY Slide a (14’4”) Side Eave Bar into each eave connector opening of the four Corner Fittings until the snap buttons engage. The rafter connector opening of the Corner Fitting should be pointing up and inwards, and the leg connector opening should be pointing downwards.
- Page 5 30’ ASSEMBLY INSTRUCTIONS CLASSIC FRAME TENTS RAFTER / PEAK ASSEMBLY If needed, position a tent jack near the center of the tent to support the 6-Way Crown Fitting and Rafters while assembling. You may also need a ladder when connecting the rafters to the crown fitting.
- Page 6 30’ ASSEMBLY INSTRUCTIONS CLASSIC FRAME TENTS CROSS BRACING IMPORTANT: Cross Bracing Tubing and Fittings are supplied with the tent framing and must first be in place before raising the tent on the legs. For stability and to prevent frame bowing, solid interior bracing using 14’4”...
- Page 7 30’ ASSEMBLY INSTRUCTIONS CLASSIC FRAME TENTS SECURING COVER While the tent is at its lowest position, finish adjusting the fit of the Cover and secure it to the frame with the cover straps and buckles. Neatly tuck excess strapping behind the buckle. Adjust all the Legs to the desired tent height.
- Page 8 30’ DISASSEMBLY INSTRUCTIONS CLASSIC FRAME TENTS Remove Sidewalls, Liners and Drapes. Fold and roll for cleaning and/or storage. Loosen all Ratchet Straps or Guy Ropes. Leave Corner anchoring in place for now. Remove all anchoring from the side Mid-Rafter Legs. Adjust the tent height on all the Legs to the lowest height.
Need help?
Do you have a question about the ETI 30’CLASSIC FRAME TENTS and is the answer not in the manual?
Questions and answers