Advertisement
Contents
Connections
Settings
Configure the IP address.
If you are using a broadband router (DHCP function), the information
0
required for network connection such as the IP address will be
automatically configured since the DHCP function is set to "On" in the
default settings of this unit.
Set up the IP Address, Subnet Mask, Gateway and DNS server
0
information only when assigning a fixed IP address or when connecting
to a network without DHCP function.
o DHCP
Selects how to connect to the network.
On
(Default):
Off:
o IP Address
Set the IP address within the ranges shown below.
The Network Audio function cannot be used if other IP addresses
0
are set.
CLASS A: 10.0.0.1 - 10.255.255.254
CLASS B: 172.16.0.1 - 172.31.255.254
CLASS C: 192.168.0.1 - 192.168.255.254
Front panel
Rear panel
Playback
Configure the network settings
automatically from your router.
Configure the network settings manually.
Remote control
unit
Settings
o Subnet Mask
When connecting an xDSL modem or connector adapter directly to
this unit, input the subnet mask indicated in the documentation
supplied by your provider. Normally input 255.255.255.0.
o Gateway
When connected to a gateway (router), input its IP address.
o DNS
Enter the DNS address indicated in the documentation supplied by
your provider.
o Save
Save settings
0 If you cannot connect to the Internet, recheck the connections and settings.
(v p. 31)
0 If you do not understand about Internet connection, contact your ISP (Internet
Service Provider) or the store from which you purchased your computer.
110
Index
Tips
Appendix
Advertisement
