PSEN ix2 F8 code
Safety
Intended use
The PSEN ix2 F8 code is an interface for connecting series-connectable PSENcode,
PSENslock, PSENini sensors to an evaluation device.
}
Connection to Safety Device Diagnostics (SDD) and forwarding of diagnostic informa-
tion from the connected sensors to a fieldbus module. Further information is provided in
the document entitled "System Description Safety Device Diagnostics".
}
Series connection of PSEN sensors and connection to an evaluation device
A max. of 8 PSEN sensors can be connected to a PSEN ix2 F8 code. All sensors must be
8-pin, with 2 safety inputs each.
The following is deemed improper use in particular:
}
Any component, technical or electrical modification to the product
}
Use of the product outside the areas described in this manual
}
Use of the product outside the technical details (see
Safety regulations
Additional documents that apply
Please read and take note of the following documents:
}
Operating manual for the relevant Pilz safety device
}
Operating manual for the fieldbus module, for example SDD ES ETH or SDD ES
PROFIBUS
}
System description "Safety Device Diagnostics"
You will need to be conversant with the information in these documents in order to fully un-
derstand this manual.
Operating Manual PSEN ix2 F8 code
1003867-EN-02
[3] Terminal block X5, terminals Y2+Y3, Y4+Y5, Y6+Y7 are bridged when de-
livered
Terminal block X6, terminals Y2+Y3, Y4+Y5, Y6+Y7 are bridged when de-
livered
NOTICE
EMC-compliant electrical installation
The product is designed for use in an industrial environment. The product
may cause interference if installed in other environments. If installed in other
environments, measures should be taken to comply with the applicable
standards and directives for the respective installation site with regard to in-
terference.
Technical details [
19]).
7