Safety; Intended Use; Safety Regulations; Safety Assessment - Pilz PDP20 F 4 mag Operating Manual

PDP20 F 4 mag

Safety

Intended use

The sensor interface PDP20 F 4 mag enables up to 4 sensors to be connected in series.
Permitted sensors are sensors with a N/O / N/O combination and the Pilz sensors listed in
the section entitled "Permitted sensors from Pilz".
The sensor interface meets the requirements in accordance with:
EN 60204-1
}
EN 60947-5-3
}
EN 62061: up to max. SIL CL 3
}
EN ISO 13849-1: up to max. PL e
}
If multiple sensor interfaces PDP20 F 4 mag are connected in series, 3 additional sensors
per sensor interface may be connected in series.
The following is deemed improper use in particular:
Any component, technical or electrical modification to the product
}
Use of the product outside the areas described in this manual
}
Use of the product outside the technical details (see
}

Safety regulations

Safety assessment

Before using a unit it is necessary to perform a safety assessment in accordance with the
Machinery Directive.
Functional safety is guaranteed for the product as a single component. However, this does
not guarantee the functional safety of the overall plant/machine. In order to achieve the re-
quired safety level for the overall plant/machine, define the safety requirements for the
plant/machine and then define how these must be implemented from a technical and organ-
isational standpoint.
Operating Manual PDP20 F 4 mag
24737-EN-03
INFORMATION
This gives advice on applications and provides information on special fea-
tures.
NOTICE
EMC-compliant electrical installation
The product is designed for use in an industrial environment. The product
may cause interference if installed in other environments. If installed in other
environments, measures should be taken to comply with the applicable
standards and directives for the respective installation site with regard to in-
terference.
Technical details [ 13]).
5