Safety; Intended Use; Safety Regulations; Additional Documents That Apply - Pilz PSEN ix2 F4 code Operating Manual

PSEN ix2 F4 code

Safety

Intended use

The PSEN ix2 F4 code is an interface for connecting series-connectable PSENcode,
PSENslock, PSENini sensors to an evaluation device.
}
Connection to Safety Device Diagnostics (SDD) and forwarding of diagnostic informa-
tion from the connected sensors to a fieldbus module. Further information is provided in
the document entitled "System Description Safety Device Diagnostics".
} Series connection of PSEN sensors and connection to an evaluation device
A max. of 4 PSEN sensors can be connected to a PSEN ix2 F4 code. All sensors must be
8-pin, with 2 safety inputs each.
The following is deemed improper use in particular:
}
Any component, technical or electrical modification to the product
}
Use of the product outside the areas described in this manual
}
Use of the product outside the technical details (see

Safety regulations

Additional documents that apply

Please read and take note of the following documents:
} Operating manual for the relevant Pilz safety device
}
Operating manual for the fieldbus module, for example SDD ES ETH or SDD ES
PROFIBUS
}
System description "Safety Device Diagnostics"
You will need to be conversant with the information in these documents in order to fully un-
derstand this manual.

Use of qualified personnel

The products may only be assembled, installed, programmed, commissioned, operated,
maintained and decommissioned by competent persons.
A competent person is someone who, because of their training, experience and current pro-
fessional activity, has the specialist knowledge required to test, assess and operate the
work equipment, devices, systems, plant and machinery in accordance with the general
standards and guidelines for safety technology.
Operating Manual PSEN ix2 F4 code
1003823-EN-02
NOTICE
EMC-compliant electrical installation
The product is designed for use in an industrial environment. The product
may cause interference if installed in other environments. If installed in other
environments, measures should be taken to comply with the applicable
standards and directives for the respective installation site with regard to in-
terference.
Technical details [ 16]).
7