Table of Contents
Advertisement
Electrical connection
The wine conditioning unit is supplied
with a mains cable with moulded plug
ready for connection to an earthed
socket.
The socket must be easily accessible
after the wine conditioning unit has
been installed. If the socket is not easily
accessible, ensure that a suitable
means of disconnection is provided on
the installation side for each pole.
The electrical system must comply with
local and national safety regulations
(BS 7671 in the UK).
For safety reasons, we recommend
using a type residual current device
(RCD) in the assigned electrical
installation for connecting the wine
conditioning unit.
If the mains connection cable is
damaged, it must only be replaced with
a specific mains connection cable of
the same type (available from the Miele
Customer Service Department). For
safety reasons, such replacement may
only be carried out by a qualified
specialist or the Miele Customer
Service Department.
52
These operating instructions and the
data plate indicate the nominal power
consumption and the appropriate fuse
rating. Compare this information with
the data of the on-site electrical
connection.
If in any doubt, consult a qualified
electrician.
Do not connect the wine conditioning
unit to a stand-alone inverter such as
those used with an autonomous power
supply, e.g. solar power. When the wine
conditioning unit is switched on, power
surges could result in an auto switch-
off. This could damage the electronic
module.
Advertisement
Table of Contents
