Table of Contents
Advertisement
Electrical connection
Risk of electric shock!
The wine conditioning unit must only
be switched on when it has been in-
stalled in accordance with the instal-
lation instructions.
Ground the wine conditioning unit.
The wine conditioning unit must not
be grounded via a gas pipe.
If in doubt, have a suitably qualified
and experienced electrician check
that the wine conditioning unit com-
plies with relevant regulations.
Do not install a fuse into neutral cur-
rent or grounding electrical circuit.
Do not use an extension cord or
power bar.
Do not use a frayed or damaged
power cord.
Risk of electric shock!
For protection against electric shock,
this wine conditioning unit is
equipped with a pole-free plug which
is protected against reverse polarity.
The plug must be grounded in the
usual way.
Do not remove the round grounding
connector pin from the plug.
Use only a grounded plug adapter.
Wait for 1 hour after installation before
plugging the wine conditioning unit into
the power supply. This allows coolant
and refrigerator oil to settle in accor-
dance with regulations.
Ensure that the voltage of the power
supply corresponds to the connection
voltage of the wine conditioning unit. A
power supply of 110–120 V, 60 Hz and
10 –16 Amps, which is protected by a
power switch or a fuse, is required to
operate the wine conditioning unit.
The manufacturer recommends operat-
ing the wine conditioning unit on a sep-
arate circuit to avoid overloading the
electrical circuit.
All relevant legal electrical, fire, and
building regulations must be observed
when installing the outlet and/or the
wine conditioning unit.
In certain countries, wine conditioning
units are required to be connected to
the electrical supply via a wall-mounted
ON/OFF switch.
To avoid the risk of fire, electric shock,
or other injuries, the wine conditioning
unit must be installed and connected by
a suitably qualified electrician in accor-
dance with all relevant local and na-
tional regulations and standards, in-
cluding fire prevention.
The outlet must be easily accessible so
that the wine conditioning unit can be
quickly disconnected from the electrical
supply in case of an emergency.
Installation
49
Advertisement
Table of Contents
