Programming The User Melody - Yaesu VX-8GR/GE Operating Manual

CTCSS/DCS/EPCS O
CTCSS/DCS/EPCS B
P
ROGRAMMING THE
Three User Beep Memories are provided, allowing you to create unique original beep
tone melodies.
Each User Beep Memory can store up to 64 steps with three octaves ("C1" through "B3").
1. Press and hold the m key for one second to enter the Set Mode.
2. Rotate the DIAL knob to select Set Mode Item 10: BEEP
MELODY.
3. Press the m key briefly to enable adjustment of this Set
Mode Item.
4. Rotate the DIAL knob to select the memory slot into which
you wish to store your programmed beep melody. Avail-
able selections are 1, 2, and 3. The previously stored beep
melody will be displayed.
5. Press the M key to enable programming the beep melody.
Press and hold the h key for one second to clear any
previous beep melody, if desired.
6. Rotate the DIAL knob to select the first beep tone of the
User Beep Melody. Available selections are C1 - B3, and
POS (rest).
7. Press the M key, then rotate the DIAL knob to set the
length of the first beep tone. Available selections are 10ms
(10 msec) - 2500ms (2.5 sec).
8. Press the M key to accept the first beep tone of the User
Beep Melody.
9. If you make a mistake, press the B key to back-space
the cursor, then re-enter the correct beep tone or length.
10. Repeat steps 6 - 9 until you have completed the User Beep
Melody.
11. When there is a beep tone, which you wish to delete, bring
the cursor to that beep tone using the B/M key, then
press the c key repeatedly until the "SELECT" notation
in the "Operation Mode" slot turns into "DELETE". Now,
press and hold in the c key for one second to delete that beep tone.
C1 D1 E1 F1
38
U M
SER ELODY
G1 A1 B1 C2 D2
PERATION
O
ELL PERATION
E2 F2 G2 A2 B2
VX-8GR/GE O
Step Operation Mode
Beep Tone
Memory Slot Tone Length
C3 D3 E3 F3 G3
M
PERATING
A3 B3
ANUAL