1-4 DISTRESS TRANSMISSION
1-4-1
EMERGENCY
1) Press the
2) In case, if there is no response, transmit again from the 1
after approximately 4 minutes 30 seconds (4 minutes ~ 5 minutes).
3) Press
HOW TO USE SN-100 NBDP TERMINAL
1-5
CHANNEL SELECTION
1-5-1
1) Change [CH] on the screen ➜ Select the desired channel with [Numeric buttons] ➜
Press [Enter] button.
2) Press [F6] ➜ Select the desired channel with [Numeric buttons] ➜ Press [Enter] button.
FREQUENCY SELECTION
1-5-2
1) Transmission (TX)
Press [F7] ➜ Input the desired communication frequency with [Numeric buttons] ➜
Press [Enter] button.
2) Reception (RX)
Press [F8] ➜ Input the desired communication frequency with [Numeric buttons] ➜
Press the [Enter] button.
ARQ MODE
1-5-3
8
TRANSMIT A SIGNAL (DISTRESS) BY
TRANSMISSION KEY
KEY and hold on for 5 seconds to transmit a signal.
to stop the transmission.
channel to the 6
channel
st
th