Dsc Mode - Samyung ENC SRG-150DN Instruction Manual

2) Press the key
buttons and then press
1-2-2 FREQUENCY SELECTION
1) Press on the front panel of keyboard repeatedly and select [TX]. Input the
desired frequency with numeric buttons and press
2) Press on the front panel of keyboard repeatedly and select [RX]. Input the
desired frequency with numeric buttons and press
[Ref.] If frequency is out of range then it cannot be input with 'beep' alarm will be
sound off. The TELEX frequency interlocked with the DSC by the Radio Regulation
Appendix 15 cannot be input.
TRANSMISSION (TX) & RECEPTION (RX)
1-2-3
1) Transmission (TX)
Input the transmission / reception (TX/RX) frequency, which will be used for voice
communication.
➜
reception (TX/RX) frequency to use it for voice communication➜ Press the microphone
switch (PTT) and communicate.
[Ref.] Press the button
frequency with the dial from 10Hz to 10MHz by selecting it with the buttons
[Ref.] In case, if there is no ATU tuning data value for the first channel then ATU tuning
for the emergency TX frequency (2,182 / 2,1875 / 4,2075 / 6,312 / 8,4145 / 12,477 /
16,8045 kHz) runs automatically.
2) Reception (RX)
It is easy to hear by turning down the GAIN and turning up the VOLUME on noiseless
condition of [VOLUME] and [GAIN].
[Ref.] Press the button
frequency with the dial from 10Hz to 10MHz by selecting it with the buttons

DSC MODE

1-3
CHANNEL SELECTION
1-3-1
6
repeatedly to select CH ➜ Input the desired channel with numeric
.
switch to the
put on [TX] and if you press
, .
, put on [RX] and if you press
, .
.
.
mode ➜ Input the transmission /
, you can change the
, you can change the